Nincs meghatározva az anyaga! Bármiből lehet, csak meg kell felelnie ezeknek a paramétereknek: Each cable must have its own separate attachment which:
- is able to withstand a tensile force of 70kN;
- is able to accommodate a cable end fitting with a minimum inside diameter of 15mm. However, this will not apply when fitted to a car utilising a survival cell, transmission casing or uprights the type of which were used at an Event during the 2004 Championship season.
Each wheel may be fitted with one or two cables, dependent upon their performance when tested under FIA Test Procedure 03/05. If one cable is fitted it must exceed the requirements of 3.1.1 of Test Procedure 03/05 and if two are fitted each must exceed the requirements of 3.1.2.
Each cable must exceed 450mm in length and must utilise end fittings which result in a tether bend radius greater than 7.5mm. However, the latter will not apply when fitted to a car utilising a survival cell, transmission casing or uprights the type of which were used at an Event during the 2004 Championship season.
Akár mindkettőnknek igaza lehet.
/spinrightfast.gif ":)")
/rollonfloor.gif ":)")
